Why Aritech Security System device fails to operate?
If an Aritech Security System device isn't working, the control panel might have incorrect cause and effect programming. You should verify the cause and effect programming on the control panel.
What to do if Aritech Security System shows no response or is missing?
If your Aritech Security System is not responding or is missing, it could be due to an incorrect address setting or incorrect loop wiring (polarity reversed). Check the address setting and loop wiring to resolve this issue.
Coverage specifications for white flash sounder-beacons in wall mount configurations.
Coverage specifications for red flash sounder-beacons in wall mount configurations.
Detailed diagrams and dimensions for the shallow base mounting option.
Detailed diagrams and dimensions for the deep base mounting option.
Coverage specifications for white flash sounder-beacons in ceiling mount configurations.
Coverage specifications for red flash sounder-beacons in ceiling mount configurations.
Diagrams and dimensions for the shallow base ceiling mount.
Diagrams and dimensions for the deep base ceiling mount.
Procedure for setting a unique numeric address for each device.
How to select tone, adjust volume, and set flash rate using DIP switches.
Guidelines for annual inspection and testing of the device.
Detailed technical parameters including voltage, current, sounder, and beacon specs.
General| Operating Voltage | 9-16VDC |
|---|---|
| Operating Temperature | -10°C to +55°C |
| Technology | Passive Infrared (PIR) |
| Detection Principle | Infrared |
| Detection Angle | 90° |
| Humidity Range | 95% RH non-condensing |
| Tamper Protection | Yes |
| Current Consumption | 20mA (typical) |
To Next Page
