ARITERM SWEDEN AB Installation, Operation and Maintenance - 2007.10.26- 11/12
After installation the burner has to be adjusted. To test every power range, press plus key for 8 seconds in On/Off menu, then can high, low and min modes be tested
manually. Returning to normal position: Press minus key once.
ATTENTION! In this function, the burner won’t stop when the boiler water reaches desired temperature: boiling risk!
If these instructions are not followed during installation, operation and maintenance,
the obligations of Ariterm AB under the warranty regulations are no longer binding.
Ariterm reserves the right to alter any details and specifi cations without prior notice.
Flue gas temp. High CO
Retailer / Installer
Installed by Inst. date
O
2
CO
2
Effi ciency Draught (mm) Fan Effect %
Flue gas temp. Low CO O
2
CO
2
Effi ciency Draught (mm) Fan Effect %
Flue gas temp. Min CO O
2
CO
2
Effi ciency Draught (mm) Fan Effect %
Air-fuel ratio
Air-fuel ratio
Air-fuel ratio
INSTALLER
INSTALLATION PROTOCOL
To Next Page
Loading...
