10 MAIN MENU
10.1 ABOUT THE USER MENU
The user interface gives you the
opportunity to use many settings and
functions of the receiver. Some buttons on
the remote control allow you to access the
functions of the device directly. The most
important buttons of the remote control
are described, for example, EPG, MENU,
OK. Other buttons are multifunctional and
their operation depends on the device
mode selected by the user. Below is a
summary of how to use some of the
functions of the device available through
the user menu.
1. To move the cursor up and down the
menu, use the up-down arrow buttons of
the remote control.
2. To move the cursor left and right menus
and to enable sub-menus, use the right-
left arrow buttons of the remote control.
3. To enter the sub-menu, use the OK
button.
4. The EXIT button is used to exit the
menu or function.
5. When using the sub-menu, the OK
button is used to confirm the selection.
10.2 MENU
Press the MENU button of the remote
control to display the following main menu.
11 INSTALLATION
The installation menu is used to set the
parameters of the antenna installation and
to search for channels on the satellite.
11.1 ANTENNA CONNECTION
Choose one of the two available options
depending on which installation you have.
There are two options to choose from:
fixed antenna (typical installation with one
converter) and antenna with turntable.
11.2 LIST OF SATELLITES
In this menu you need to select the
satellites that you want to use. In this
menu, you can also edit, add and delete
satellites if necessary.
11.3 ANTENNA SETTINGS
In this menu, detailed operating
parameters of previously selected
satellites are set, depending on the
antenna installation. "transponder" option
to change the frequency and check
whether each V and H polarization is
working properly.
11.4 SEARCH ONE SATELLITE
In this menu we can search for channels
from one selected satellite. There are
three search modes:
Automatic – the so-called blind scan,
consists in automatically searching for
available frequencies from the
satellite and then searching them one
by one.
According to the TP list – the receiver
searches only frequency by frequency
according to the list saved for the
selected satellite. This list can be
edited in a separate menu.
FastScan – the receiver searches the
channels of the selected provider.
You can add channels to an existing
list or replace an existing list with
new channels. Please note that the
search result and the operation of
this function depends solely on the
provider.
11.5 SEARCH SEVERAL
SATELLITES
In this menu we can search for channels
from several satellites. Satellites will be
searched automatically one by one in the
order in which they are marked in the list
of satellites.
11.6 LIST OF TRANSPONDERS
Select the satellite by pressing the
left/right arrows, and then using the
up/down buttons the desired frequency.
Newly found channels from this frequency
will be added to the end of the channel list.
11.7 SEARCH TERRESTRIAL TV
AUTOMATICALLY
In this menu we can search for channels
automatically – the receiver searches only
To Next Page
Loading...