001-11502-EN rev. 10
How to use the KWIKtrak Gate 10
4) When the ceiling lift is returned under activation station #2, the gate stoppers will go back to
their closed position, blocking the end of the tracks.
Fig. 4
Activation Station #2
Activation Station #1
5) The X-Y’s mobile track can again travel freely.
NOTE: The ceiling lift must always be routed slowly under an activation station. If the lift is
moved too quickly, it may not be detected by the station and the gate’s position would remain
unchanged. To close the gate, move the lift slowly under activation station #2.
To Next Page
Loading...