Arjo KWIKtrak - Electromagnetic Immunity

001-11502-EN rev. 10
Electromagnetic Compatibility 17
Electromagnetic Immunity
Guidance and Manufacturer’s Declaration -
Electromagnetic Immunity - For all Equipment and Systems
The KWIKtrak GateLVLQWHQGHGIRUXVHLQWKHHOHFWURPDJQHWLFHQYLURQPHQWVVSHFL¿HGEHORZ
The customer or the user of the KWIKtrak Gate should make sure that it is used in such
environments.
Immunity test
IEC 60601 test
level
Compliance
level
Electromagnetic environment -
guidance
Electrostatic
discharge
(ESD)
IEC 61000-4-2
±8 kV contact
±15 kV air
±8 kV contact
±15 kV air
Floors should be wood, concrete or
FHUDPLFWLOH,IÀRRUVDUHFRYHUHGZLWK
synthetic material, the relative
KXPLGLW\VKRXOGEHDWOHDVW
Electrical fast
WUDQVLHQW௘௘EXUVW
IEC 61000-4-4
Not applicable Not applicable
Mains power quality should be that
of a typical commercial or hospital
environment.
Surge
IEC 61000-4-5
Not applicable Not applicable
Mains power quality should be that
of a typical commercial or hospital
environment.
Voltage dips,
short
interruptions
and voltage
variations on
power supply
input lines
IEC 61000-4-11
Not applicable Not applicable
Mains power quality should be that
of a typical commercial or hospital
environment. If the user of the
KWIKtrak Gate System requires
continued operation during power
mains interruptions, it is
recommended that the
KWIKtrak Gate System be powered
from am uninterrupted power supply
or a battery.
Power
frequency
௘௘+]
PDJQHWLF¿HOG
IEC 61000-4-8
$௘௘P
50/60 Hz
$௘௘P
50/60 Hz
3RZHUIUHTXHQF\PDJQHWLF¿HOGV
should be at levels characteristic of a
typical location in a typical
commercials or hospital
environment.