Arjo MAXI MOVE - Page 2

Raise lever
Remove locking pin.
Press locking clip thumb pads. Lift attachment up (A) and away (B) from the T-bar.
Fit attachment around
T-bar, thumb pads forward.
Locking clip is fully
engaged.
Use lever as a crank. Turn
it one clockwise rotation.
1
2
1
2
Remove attachment
Install attachment
Electrical power fail – lower the jib
A
B
Markings on the attachment
are aligned.
1
2
3
ArjoHuntleigh AB
Hans Michelsensgatan 10
211 20 Malmö, Sweden
www.arjo.com
001-25215-EN Rev 0 • 05/2020 • Page 2/2