Arjo Maxi Sky 600 ECS User Manual (English)

Questions and Answers:

J
Jamie RogersAug 4, 2025
What to do if my Arjo Maxi Sky 600 ECS ceiling lift does not work when I press the buttons on the handset?
- D
  David PinedaAug 4, 2025
  If the ceiling lift doesn't respond to the handset buttons, ensure the emergency stop isn't activated by gently pushing up on the reset switch plastic insert. If the charging station light is on, move the ceiling lift away from the charging station. Check if the buttons on the ceiling lift cassette are working; if they do, the handset might be the issue. Also, verify the charge on the ceiling lift. Slide the ceiling lift over the clip-on charging station and check if the yellow light turns on. If the ceiling lift goes past the charger, contact your local Arjo representative.
M
mtranAug 13, 2025
What to do if the red “service” light is flashing on my Arjo Medical Equipment?
- C
  Courtney SmithAug 14, 2025
  If the red “service” light is flashing, and the unit starts and stops repetitively, or emits a beep, it could be due to several reasons. The ceiling lift cassette might be under its overheat protection; wait 10 to 30 minutes until the red light turns off, then press the “UP” button. If the load is over the safe working load, return the ceiling lift cassette to the charging station. Low batteries can also cause this; return the ceiling lift cassette to the charging station to charge. For maintenance, it is recommended to contact your local Arjo representative.
J
Jerry OrtegaAug 25, 2025
What to do if the ECS cassette LED battery indicator does not light up on my Arjo Maxi Sky 600 ECS?
- G
  garciaandreaAug 25, 2025
  If the ECS cassette LED battery indicator doesn't light up, push the red cord plastic insert to turn the cassette on. Verify that the electrical outlet has power and that the charger is connected to the ECS cable adaptor on the fixed track. Also, ensure all extensions used are connected and check for an interrupted contact strip along both sides of the track. Check for damage on the contact blades in each contact box.