Remove visual residue
Clean
Step 13–23 for Air spa only
The bathtub should be in upright position
with all functions turned off.
Put on protective gloves
and eye wear.
Shower with water to
remove visible residue.
Spray disinfectant on all internal surfaces
and all sides of the accessories.
Scrub internal surfaces and
accessories thoroughly.
Recline the
bathtub.
Place the
disinfection
spray handle into
the inlet. Turn
left or right to
secure tightly.
Place the
shower handle
into the inlet.
Turn left or
right to secure
tightly.
Activate the
shower button.
Lift out the disinfection spray
handle.
Raise
bathtub to
upright
position.
For Parker
without Air
spa go to
step 24.
2
5
11 12
3 4
1
Close the drain.
6 7 8
10
19 20 21 22 23
M
I
X
8
0
7
0
6
0
50
4
0
3
0
2
0
Deactivate the
disinfection
button.
18
MI
X
8
0
7
0
6
0
5
0
4
0
3
0
2
0
Spray into the bathtub until the flow meter shows correct mixing value according
to the Instructions for use. Adjust knob on the suction hose if needed.
Mixing
temperature
20°C (68°F).
Spray disinfectant in the drain.
Scrub drain with a brush.
9
13 14 15 16
17
Press and hold the trigger. Disinfectant must
flow from all nozzles for at least 30 seconds.
Press and hold the trigger. Clean water must
flow from all nozzles for at least 30 seconds.
Release the trigger and
remove the spray handle.
Remove the
shower handle.
Activate the
disinfection
button.
5 seconds
5 seconds
Open the drain.
Place all accessories at the bottom.
Put back the
spray handle.
M
I
X
8
0
7
0
6
0
5
0
4
0
3
0
2
0
QUICK REFERENCE GUIDE - CLEANING AND DISINFECTION
Parker
Continue with the steps on the next page
Disinfect with integrated spray handle
Determine the disinfectant mixing ratio
08.AL.01_5EN • 06/2020 • Page 1/4
To Next Page
Need help?
General
