Why is the water flow slow from the shower and filling spout in Arjo Bathtubs?
If the water flow from both the shower and filling spout of your Arjo Bathtubs is slow, check the incoming hot water line to see if it is hot. Also, inspect and clean the filter for the incoming water according to the Care and Preventive Maintenance section on page 52.
How to fix slow water flow to the shower in Arjo Bathtubs?
If the water flow to the shower in your Arjo Bathtubs is slow, inspect and clean the shower head. Refer to the Care and Preventive Maintenance section on page 52 for instructions.
What to do if there's water on the ground near my Arjo Bathtubs?
If you find water on the ground near your Arjo Bathtubs, immediately check for leaks in the incoming water lines and the bath drainage hose. Additionally, the bath may have short-circuited, causing it to fill continuously. In either case, turn off both the electrical and water supplies to the unit.
Why won't the auto fill function stop filling my Arjo Bathtubs?
If the auto-fill function on your Arjo Bathtubs doesn't stop, it might be due to residue buildup on the mechanical sensor plugs. Refer to the Cleaning and Disinfection Instructions on page 40 for guidance.
What to do if the fill or shower function stops on my Arjo Bathtubs?
If the fill or shower function on your Arjo Bathtubs stops working, reset the scalding protection. Follow the instructions for 'Reset scalding protection (P220 only) (5 steps) on page 18' or 'Reset scalding protection (P300 only) (4 steps) on page 19'.
What to do if disinfection does not work on Arjo Bathtubs?
If the disinfection process isn't working on your Arjo Bathtubs, ensure the bathtub is completely empty. Also, make sure that shower, fill or Hydromassage system, Hydrosound system are not activated. If the LED on the control panel is flashing and beeping P300 only, it means the disinfection level in the bottle is low and needs replacement. See section Cleaning and Disinfection Instructions on page 40!
Why is the sound not working on my Arjo Bathtubs Sound & Vision system, but the light is?
If the sound isn't working on your Arjo Bathtubs' Sound & Vision system, but the light is, the USB memory stick might be defective. If possible check the USB LED light for indication: Solid light power 21 Flashing light reading! Try using a different USB memory stick.
What to do if the Sound & Vision system hand control is not working on Arjo Bathtubs?
If the hand control for the Sound & Vision system in your Arjo Bathtubs isn't working, check if the LED on the remote control flashes when active. If it doesn't, replace the Sound & Vision system hand control.
Critical safety precautions to prevent injury and hazards.
Daily checks and preparations before patient use.
Safety feature to prevent high water temperatures.
Functionality and use of the optional disinfection unit.
Step-by-step guide for bathing using a lift hygiene chair.
Cleaning and disinfection process after patient use.
Step-by-step guide for bathing using a lift bath trolley.
Guidelines and precautions for cleaning and disinfection.
Procedure for replacing the disinfectant bottle.
Using the spray handle for disinfection.
Using a spray bottle for cleaning and disinfection.
Disinfecting the hydromassage system automatically.
Manual disinfection of the hydromassage system.
Daily, weekly, monthly, and yearly maintenance tasks.
Testing all system functions for proper operation.
Annual servicing and calibration by qualified technicians.
To Next Page
General
