ARK Tamo - Installing on a Wall

14
5 Installing on a wall
Please refer to www.keysafe.co.uk for installation videos
To mount the Tamo to a wall, the following tools
are needed:
• 5 mm masonry drill bit
• Drill
• Marker pen or pencil
• T30 Torx screwdriver
• Marking template
• Spirit level
• Safety goggles (recommendation)
• Dust pan
• Brush
Hold the template at the desired height on the wall
and mark the holes on the surface (see Image 9).
* Do not use the keysafe to mark/drill the holes
astheunitwillllwithbrickdustandmayfailto
work (see Image10).
Make sure the holes line up with the horizontal
centre of the brick.
• Set the template aside.
• Put on eye protection.
• Drill four holes.
Make sure the holes are 70 mm deep. Mark the drill
with tape before drilling.