16
• Clean out the dust and debris from the holes
by blowing gently into the holes.
• Place the Tamo over the holes.
• Use the four included screws (Image11).
• Drive the screws directly into the brick using a
T30 Torx screwdriver. Do not use power tools.
• Tighten the screws until the heads are snug
against the back of the keysafe.
Do not over-tighten the screws.
• Close the Tamo and weather cover.
6 Using your Tamo
6.1 Opening/unlocking
1. Open the weather cover (Image12).
2. Pull down the clear button.
3. Enter your code.
4. Rotate the open dial 180° clockwise to open.
5. If the incorrect code has been entered and
the open dial is forced, the dial will unlatch
from the locking mechanism and rotate freely
without opening. Reset the open dial by
rotating the open dial to the locked position.
The open dial will snap back into place.
To Next Page
Loading...