Check that the battery has been installed correctly.
Check that the gap between parts is not more than 12mm.
Check that the Window/Door Sensor is not more than 20 metres from
the Control Panel. If the Window/Door Sensor is mounted near metal
objects, if any have to be relocated.
Arm the Control Panel and open the secured door. The LED on
the Window/Door sensor and control panel should light momentarily.
Check that the 4 x 'AA' batteries have been installed correctly.
Check wiring has been correctly connected and damage to cable has
not occurred during installation.
Window/Door Sensor
AM553 Compact Extension Siren (not included)
ACCESSORIES
More Movement Activated Sensors and Wireless Window/Door Sensors
can be added to the AM500 system if desired to provide additional
security.
AM551 Movement Activated Sensor
AM552 Wireless Window/Door Sensor
Installation of the Movement Activated Sensors and Window/Door
Sensors is identical as described in these instructions.
AM553 Extension Siren
Installation of the external siren:
- Connect the wires of the Siren to the 'EXT SIREN' terminals inside
the Control Panel wiring compartment.(Red wire to +ve and Black
wire to –ve).
- Run the cable to another room or even outside under eaves and
install 4 x 'AA' batteries inside the Extension Siren.
The Extension Siren will now sound when the Control Panel Siren
sounds.
IMPORTANT
DO NOT drop any alarm components.
DO NOT install the Movement Activated Sensors close to an internal
heating or cooling source.
DO NOT install the alarm in a position where direct sunlight may occur.
DO NOT use rechargeable batteries in any alarm components.
Use alkaline type batteries only. DO NOT mix different types of batteries
in the Control Panel or Extension Alarm.
To Next Page
Loading...