Installation and Operation Instructions
Compact Security FloodLight
Important! Please read these instructions carefully.
MAL615 (Series 5)
Introduction
The Arlec MAL615 Movement Activated Sensor Light is a compact sensor light unit. It controls
two PAR38, 150W floodlight bulbs for wide area illumination. The MAL615 can be used to provide lighting
for security and general purposes in a variety of locations around the home or workplace.
Overview
Mounting Plate
Mounting Plate screws
Joint & Clamp Screw
Sensor Head
Screws for rawl plugs
for fixing Junction Box
Junction Box
Locknuts
Weatherproofing
Seals
Lampholders
Sensor Controls
(underside)
Fig. 1
IMPORTANT: Loosen all lock nuts and screws on sensor and lamp holders before
making any adjustments.
NOTE: Always face control knobs on sensor downwards to ensure correct operation
Location of unit
To achieve best results for exterior use, your Movement Activated Floodlight should be securely
mounted to a wall or eaves in close proximity (max 300mm) to an existing bayonet style light fitting.
For ideal operation the sensor head should be located approx 2.5m above the area where movement
is to be sensed. This will provide the best scanning sensitivity and detection area.
• Although this product is weatherproof it is preferable to mount your Floodlight in a sheltered or
semi-sheltered location.
• To avoid damage to unit - do not aim the sensor towards the sun.
• To avoid nuisance triggering, the sensor should be directed away from heat sources such as BBQ’s,
air conditioners, other outside lighting, flue vents and moving cars.
To Next Page
Need help?
General
