the back body of the appliance. All models need 2 fixing flats except the EALC070 which needs
only 1 fixing flat.) Pls.
see below pictures for
installation.
2） Hang the appliance on the hooks (shown as below). Be sure the bracket is totally hung on the
hook. Once the appliance hung on the hook, try to pull down the appliance, if the appliance is
unmovable, it means that the appliance is hooked. Mark 2 hole positions on the wall for the
two fixing flats (letter C item as below picture), and drill the holes at diameter 4mm, depth
25mm. Fix the appliance on the wall by screwing the fixing flat on the drilling hole on the
wall. (Pls. see below pictures for installation.)
4. Electrical connection
Before plugging into the socket, pls. make sure your power supply and voltage conform to
the labeled power and voltage on the appliance, also the plug matches the socket.
This product is in compliance with the electromagnetic interference prevention standard
89/336/EEC.
5. Control panel instruction
To Next Page
Loading...
