EasyManua.ls Logo

Arlec EALC070 - Post-Operation Management; Power Management and Safety Features; Daily Maintenance and Cleaning; Fault Detection and Disposal

Arlec EALC070
9 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4.When Mondays setting is finished, press the button to enter into Tuesdays setting.
Set the Monday to Sundays program in the same way and once finished, pressing the
and the program will be repeated weekly as long as the heater is not powered off or
been turned off by the switch.
4a. When the heater is working and under the unlock state, press the or and the
display will indicate the set temperature.
b. When the heater is under the comfort mode or economy mode or anti-frost mode, press
the button+or and you can enter into the temperature set mode. By pressing the
or you can regulate the temperature.
7. Power off/ power switch off
The heater will stop working if the power switch is turned off or theres a power cut off. The
time clock will stop at the power off moment, and all setting will be stored in the memory. Once
powered on, by pressing the or and the heater will restart to work.. The time clock will
go on moving from its powered off moment and all programs will continue running until reset the
time.
8. High temperature protection
The heater transfers the heat through convection and radiation. Cover this heater by textile
products in whole or in part will affect the heaters function and also result the heater itself in a
high temperature. No textile products cover the heater otherwise it may destroy or block the air
circulation and cause low efficiency for several products.
9. Daily Maintenance and cleaning
Before cleaning or maintaining the heater, plug out the power socket and wait until main body of
the appliance is completely cool.
Do not require special technical maintenance.
A vacuum cleaner and soft brush can be used to clean the surface of the heater..
Stains can be cleaned by wet rag with cleanser and water.
10. Fault Detection and Solution
Ensure the power is connected
Ensure the appliance is switched on and the LCD light is on.
Ensure the setting temperature is higher than the rooms temperature.
If problems still exist, contact technical support.
This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and
Electronic Equipment.
Do not dispose the heater as living garbage when it is end of life.
It must send to the local special recycling center or distributors for disposal.
Appliances should be disposed separately to avoid mistake disposal leading negative
effect to the environment and sanitation. Main components of the heater can be
recycled to save energy and resources. In order to remind users that the appliance
should be disposed separately, theres a cross trash can mark on the product.

Related product manuals