DSTREAM-ST Getting Started Guide Document ID: 100892_1.0_07_en
Version 1.0
Set up your DSTREAM-ST
3. Set up your DSTREAM-ST
This chapter contains instructions about connecting the DSTREAM-ST unit to your host PC and
target system.
3.1 Install the USB drivers for the DSTREAM-ST unit on
Windows
To use the DSTREAM-ST unit with a USB connection, install the USB device drivers for
your operating system. The USB drivers for the DSTREAM-ST unit are provided with Arm
®
Development Studio.
Before you begin
Ensure you have:
•
Installed Arm Development Studio. For more information, see the Arm Development Studio
Getting Started Guide.
•
Administrative privileges on your PC.
Procedure
1. Using administrative privileges, run the driver_install.bat batch file that is available in
<Arm_Development_Studio_install_directory>\sw\driver_files directory.
2. In the Arm Development Studio Driver Installation Wizard, click Next and follow the steps.
During installation, you might receive warnings such as Windows can't verify
the publisher of this driver software. You can safely ignore these warnings and
continue with the installation.
3. After the drivers are installed, click Finish.
Results
The USB drivers are now installed on your PC.
Related information
Connect and power up the DSTREAM-ST unit on page 20
Copyright © 2017–2019, 2022 Arm Limited (or its affiliates). All rights reserved.
Non-Confidential
Page 19 of 31
To Next Page
Loading...
