DSTREAM-ST Getting Started Guide Document ID: 100892_1.0_07_en
Version 1.0
Set up your DSTREAM-ST
3.2 Install the USB drivers for the DSTREAM-ST unit on
Linux
To use the DSTREAM-ST unit with a USB connection, install the USB device drivers for
your operating system. The USB drivers for the DSTREAM-ST unit are provided with Arm
®
Development Studio.
Before you begin
Ensure you have:
•
Installed Arm Development Studio. For more information, see the Arm Development Studio
Getting Started Guide.
•
Administrative privileges on your PC.
Procedure
1. Using root privileges, run the run_post_install_for_Arm_Development_Studio_vx.x.sh script
file that is available in the Arm Development Studio install directory. The x.x in the filename
denotes the Arm Development Studio version that is installed on your PC.
2. To confirm the installation, enter yes.
Results
The USB drivers are now installed on your PC.
Related information
Connect and power up the DSTREAM-ST unit on page 20
3.3 Connect and power up the DSTREAM-ST unit
This topic describes how to connect your DSTREAM-ST unit to your host PC and target hardware.
Before you begin
•
You must have installed Arm Development Studio to access the software drivers and debug
hardware configuration utilities.
•
Your target hardware must contain a debug interface supported by DSTREAM-ST. For a list of
supported connectors, see Target interface connectors in the Arm
®
DSTREAM-ST System and
Interface Design Reference Guide.
•
To connect the DSTREAM-ST unit between your PC and the target hardware, you need:
◦ The DSTREAM-ST unit.
◦ The power adapter for the DSTREAM-ST unit and the mains cable for the power adapter
that is appropriate for your region.
◦ To connect the DSTREAM-ST unit to the PC or the network, you need either:
▪ The USB cable, to connect the DSTREAM-ST unit directly to the PC using the USB 3.0
port.
Copyright © 2017–2019, 2022 Arm Limited (or its affiliates). All rights reserved.
Non-Confidential
Page 20 of 31
To Next Page
Loading...
