ARM DSTREAM-ST - Serial Wire Debug (SWD) signals

DSTREAM-ST Getting Started Guide Document ID: 100892_1.0_07_en
Version 1.0
Set up your DSTREAM-ST
When you power up the DSTREAM-ST unit, it follows a boot sequence. The LEDs identify the
progress of the boot sequence. For more information, see DSTREAM-ST unit boot sequence.
If you need to reset the DSTREAM-ST unit, press the reset button on the rear
of the DSTREAM-ST unit.
3. If you are connecting across an Ethernet network, configure the Ethernet and internet protocol
settings for your DSTREAM-ST unit. To configure these settings, use the Debug Hardware
Configure IP view in Arm Development Studio.
You can also use the Debug Hardware Configure IP view to assign a name for
the DSTREAM-ST unit. For more information, see the Arm Development Studio
documentation for Debug Hardware Configure IP view.
4. Connect the DSTREAM-ST unit to the target hardware. Use the appropriate cables and
connector. Each connector, and the appropriate cable to use for that connector, is described in
Target interface connectors in the Arm DSTREAM-ST System and Interface Design Reference
Guide.
5. Power up the target hardware.
•
When the DSTREAM-ST unit is powered-up, ensure that the air intake, on
the top of the unit, is not blocked.
•
If the DSTREAM-ST unit overheats, it shuts down, all the LEDs turn off, and
it remains in a safe state.
•
To re-initialize the DSTREAM-ST unit, press the reset button on the rear of
the DSTREAM-ST unit.
Next steps
•
Work with your DSTREAM-ST.
Related information
DSTREAM-ST unit boot sequence on page 22
3.4 DSTREAM-ST unit boot sequence
When you power up the DSTREAM-ST unit, it goes through a boot sequence. The LEDs identify
the progress of the boot sequence.
The DSTREAM-ST unit follows this boot sequence:
1.
The DSTREAM logo illuminates blue.
Copyright © 2017–2019, 2022 Arm Limited (or its affiliates). All rights reserved.
Non-Confidential
Page 22 of 31