The pack contains the following key folders:
• pcb:
— Contains the schematics and PCB top/bottom gerber plots for the board.
• logical:
— Contains the RTL source and the constraints file.
• docs. Contains the following files:
— V2M_MPS3_fmc_pinout.xlsx. This spreadsheet shows the MPS3 FMC pinout and net names.
— V2M_MPS3_fpga_pinout.xlsx. This spreadsheet shows the MPS3 FPGA pinout and net names.
— revision history.txt
— Application Note AN533 Blinky example FPGA image for the MPS3 Prototyping Board PDF
document.
• boardfiles:
— Contains the FPGA image (.bit) file and the MCC firmware (.ebf) file that must be loaded onto
the MPS3 microSD card to run the AN533 blinky design on the MPS3 board.
Example FMC board layout
The following figure shows an MPS3 board with an FMC board that is fitted to the FMC‑HPC expansion
connector.
2 Hardware description
2.17 FMC-HPC interface
100765_0000_04_en Copyright © 2017–2020 Arm Limited or its affiliates. All rights
reserved.
2-47
Non-Confidential
To Next Page
Loading...
Need help?
General
