ARM MPS3 User Manual

3.6 MCC command-line interface
The MPS3 board command‑line interface supports system command‑line input to the MCC.
This section contains the following subsections:
• 3.6.1 Overview of the MCC command-line interface on page 3-67.
• 3.6.2 MCC main command menu on page 3-67.
• 3.6.3 MCC debug menu on page 3-68.
• 3.6.4 MCC EEPROM menu (Reserved for factory use only) on page 3-69.
3.6.1 Overview of the MCC command-line interface
You must connect a workstation to UART0 to enter system commands.
The workstation settings must be:
• 115KBaud.
• 8N1 which is 8 data bits, no parity, one stop bit.
• No hardware or software flow control.
3.6.2 MCC main command menu
The following table shows the MPS3 board MCC main menu system commands.
Table 3-1 MCC main menu system commands
Command Description
CAP filename[/A]
Capture serial data to the file filename.
Use the /A option to append data to an existing file.
Copy input_filename_1
[input_filename_2]
output_filename
Copy file input_filename_1 to output_filename.
Option input_filename_2 merges input_filename_1 and input_filename_2.
DEBUG
Change to the debug menu.
DEL filename
Delete file filename.
DIR [mask]
Display a list of files in the directory.
EEPROM
Change to the EEPROM menu.
Caution
The EEPROM menu is reserved for factory use only.
FILL filename [nnnn]
Create a file filename filled with text.
nnnn specifies the number of lines to create. The default is 1000.
FORMAT [label]
Format Flash Memory Card.
HELP or ? Display this help.
HELP configfile
Display config file flags
HELP boardfile
Display board file flags
HELP imagefile
Display image file flags
HELP version
Display MCC version history
3 Configuration
3.6 MCC command-line interface
100765_0000_04_en Copyright © 2017–2020 Arm Limited or its affiliates. All rights
reserved.
3-67
Non-Confidential

ARM MPS3 Specifications

General

Brand	ARM
Model	MPS3
Category	Motherboard
Language	English