Table 3-2 MCC debug command menu (continued)
Command Description
EXIT or QUIT Return to main menu.
HELP or ? Display this help.
TIME
Display current time.
3.6.4 MCC EEPROM menu (Reserved for factory use only)
To switch to the EEPROM menu, enter EEPROM at the MCC main menu. The contents of the MPS3
board EEPROMs identify the specific board variant and might contain data to load to other devices on
the board.
Caution
Do not modify the factory-programmed EEPROM values.
The following table shows the EEPROM commands.
Table 3-3 EEPROM commands
Command Description
CONFIG 0 filename
Write configuration file to EEPROM.
EXIT or QUIT Return to main menu.
ERASECON [0]
Erase configuration section of EEPROM.
ERASEDEV [0]
Erase device section of EEPROM.
ERASERANGE [0] [start] [end]
Erase EEPROM between start and end.
ERASEIMAGE image_id
Erase image stored in board EEPROM.
ERASEIMAGES
Erase images stored in board EEPROM.
HELP or ? Display this help.
READIMAGES
Read images stored in board EEPROM.
READCF [0]
Read configuration EEPROM.
READRANGE [0] [start] [end]
Read EEPROM between [start] and [end].
3 Configuration
3.6 MCC command-line interface
100765_0000_04_en Copyright © 2017–2020 Arm Limited or its affiliates. All rights
reserved.
3-69
Non-Confidential
To Next Page
Loading...
Need help?
General
