88 89
CZ CZ
will reduce naturally. If not used, do not leave the watch
out of the battery for an extended period of time and
recharge the battery regularly.
11. Protect the watch from falls or impact; do not expose it to
extreme temperature or direct sunlight. These conditions
may cause malfunctions, or they can cause irreparable
damage. Keep the watch at room temperature if not in use.
12. The watch has a built-in battery. Do not expose it to flames
or extreme temperature due to risk of explosion.
13. Do not disassemble the watch or its accessories.
14. Do not use the product in close proximity to explosives
and chemicals.
15. Keep the product out of reach of children. It may feature
small parts posing risk of inhalation.
16. The watch software and the application itself are
innovated on a continuous basis. Therefore, the
manufacturer reserves the right to amend the instructions
and individual functions without prior notice.
17. Should you have any questions, do not hesitate to contact
the manufacturer.
coming into contact with water, immediately dry the watch
thoroughly. Damage by water or steam is not covered by
warranty.
5. You have stopped receiving incoming calls or SMS
notifications – check that the watch is paired with your
phone and the notifications are allowed in the app
[Notifications (Fig. 3)] and in the settings of your phone,
and that the do-not-disturb mode has not been activated
in the app. Make sure Bluetooth is on in your phone.
Do not pair the watch via the phone’s Bluetooth menu.
6. The watch cannot be paired with a phone – possible
solutions:
- make sure the watch and phone are charged sufficiently
- make sure your phone’s Bluetooth and GPS are
switched on and you have allowed your location/
position to be determined in your phone’s settings
- place the watch and the phone next to each other
- check the system updates in your phone
- uninstall and re-install the app
- restart your phone and switch it off then back on again
- make sure your phone meets the technical requirements
(Android 5.1+, iOS 9.0+, Bluetooth 5.0+)
7. Sensor light is blinking – data measurement or transfer
is underway.
8. Sensor light blinks even when the watch is not being worn
– it is not a flaw.
9. To ensure the correct function of the watch, it is
recommended that it be restarted or reset occasionally
and, where available, that firmware be updated in the
app. Make sure you always have the most recent version
of the app.
10. Always charge the watch for no more than 2 hours (at no
more than 5 V). Improper charging reduces the capacity
and useful life of the battery. Battery life depends on the
ambient temperature and the number of functions actively
running. When active, some functions may reduce battery
life to several hours. Over time the capacity of the battery
EN EN
To Next Page
Loading...
