83
CZ
Customise the watch face
For a successful setting of the watch face, the smartwatch and
phone need to be sufficiently charged.
In the application, tap on the “Watch faces” (Fig. 3), then on any
watch face in the gallery (Fig. 4) marked with a blue line in the
upper right corner (usually watch faces in the first row). Tap again
on the watch face (Fig. 5) and select whether to take a photo or
select an image from your phone. Edit the image in the viewport.
To transfer the image to the smartwatch, tap on “Start update”
(Fig. 5). In the event of an error message during the upload, plea-
se check whether the size of the image is suitable and whether
the phone and smartwatch are charged sufficiently. Then repeat
the process.
Messages
To receive messages and notifications, your smartwatch must be
paired with your phone, and the receipt of messages and notifica-
tions must be allowed in the WearPro app (Fig. 3). Furthermore,
you must allow the app access to messages and notifications
in the settings of your phone. (This is typically done during
installation.) )
Display activation by twisting the wrist
Allow and set it up in the WearPro app in your phone (Fig. 3).
EN
To Next Page
Loading...
