12
BLOWER OPERATION
2
5
4
3
1
6
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Make sure the collection tank is empty before using as a blower. Clear all dirt and debris from
the hose and collection tank.
3. Remove hose from the vacuum port.
4. Insert the larger end of the hose into the blower port on the back side of the power head (Fig. 2).
5. Choose the desired attachment and insert onto the end of the hose (Fig. 3).
6. Verify that the on/o switch is in the ‘O’ OFF position before plugging the power cord into the
outlet. Plug the power cord into the outlet (Fig. 4).
7. Before turning on the vacuum, firmly hold the loose end of the hose. Turn the motor on by
ipping the switch to the ‘I’ ON position (Fig. 5).
8. Once you have completed blowing, ip the on/o switch to the ‘O’ OFF position. Unplug the
power cord from the outlet (Fig. 6).
This Wet/Dry Vacuum has blowing capabilities. To use the blower feature, follow the instructions
listed below.
WARNING:ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR IN
CANADA, CSAZ94.3) BEFORE USING BLOWER.
WARNING:WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE
INHALED.
WARNING:KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
disconnect from power supply, and drain the liquid into a suitable receptacle or drain. To continue
vacuuming, refit the power head to the collection tank. After wet vacuuming, turn the machine
o and remove plug from power supply. Empty the collection tank, clean and dry the inside and
outside before storage.
REMEMBER! The foam wet lter must be removed after wet vacuuming and the reusable cloth
lter must be installed before dry vacuuming again.
To Next Page
Loading...
