ArmorAll AA256 - Installing & Cleaning Reusable Cloth Filter; Installing Reusable Cloth Filter; Removing & Cleaning Reusable Cloth Filter

14
54
1 2 3
INSTALLING REUSABLE CLOTH FILTER
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Remove the power head and place in an upside-down position.
3. Install the reusable cloth lter over the lter cage making sure the cage is completely covered
(Fig. 2 & 3).
4. Place the power head back onto the collection tank.
REMOVING & CLEANING REUSABLE CLOTH FILTER
1. With the removed power head in an upside-down position, carefully remove the reusable cloth
lter from the lter cage (Fig. 4).
2. Clean the reusable cloth lter by gently tapping or brushing dirt o󰀨. Cleaning should not be
done indoors in living areas. For optimal performance a new lter is recommended.
3.
Use a mild soap and water solution to wash reusable cloth lter and rinse with clean water (Fig. 5).
4. Allow the wet lter to air dry for 24 hours before installing onto the lter cage.
INSTALLING & CLEANING REUSABLE
CLOTH FILTER