DWEX DIGITAL LOUD-SPEAKING EXPLOSION PROOF CALL STATION
User Manual
page 12/40 armtel.com
© Armtel info@armtel.com
1.4 Design
DWEx overall dimensions are shown on Figure 1.
ARMT.665230.006-06…-08 and-23…-25
ARMT.665230.006-06…-08 and -23…-25
1 – cover; 2 – enclosureс; 3 – speaker; 4 – microphone; 5 – marking nameplate for two-
way toggle; 6 – two-way toggle; 7 – LEDs for mode indication; 8 – cable glands for cables
9-17 mm dia; 9 – marking panel; 10 – plug; 11 – cable glands for cables 7 - 13 mm dia;
12 – handset; 13 – dial pad; 14 – nameplate.
Figure 1 – Overall dimensions DWEx
In front, the cover (2) is fitted to the enclosure (1). The cover is fixed to DW enclosure
by six screws. At the top of the cover there is an integrated loudspeaker (3), under which
there is a nameplate (9) for placing a label with the designation of the subscriber in the
communication network. A microphone (4) is located under the nameplate. Speaker and the
microphone are protected from mechanical damage and direct contact with small particles
and water by the shaped grills of the enclosure cover. In lower part of the DWEx cover,
depending on the version, from one to three two-way toggle modules (6) are installed.
Above the two-way toggles there are LEDs (7) indicating the operation modes and
nameplates (5) for placing exchangeable labels, indicating the programmed functions
performed by DWEx in these positions of the two-way toggles. Instead of missing two-way
toggle modules / dial pad / button modules / handset, plugs (10) are installed.
To Next Page
Loading...
