Model Series
PD20- Standard Pump
PE20- Electronic Interface
Air Motor / Air Cap Material
A - Aluminum
Fluid Connection
B - Rp 2 (2 - 11 BSP parallel)
Fluid Caps & Manifold Material
A - Aluminum
Hardware Material
P -Carbon Steel
Seat Material
Ball Material
Diaphragm Material
Revision
B - Revision
Specialty Code 1 (Blank if no Speciality Code)
B - Solenoid 12 VDC, 24 VAC AND 22 VAC
D - Solenoid 24 VDC, 48 VAC AND 44 VAC
A - Solenoid 120 VAC,110 VAC AND 60 VDC
C - Solenoid 240 VAC, 220 VAC AND 120 VDC
G - Solenoid 12 VDC ATEX / IECEx
H -
Solenoid 24 VDC ATEX / IECEx
K - Solenoid 220VAC ATEX / IECEx
N - Solenoid with no Coil
P -
Ported Motor (No Major Valve)
NOTICE: All possible options are shown in the chart, however, certain combinations may not be recommended.
G - End of Stroke ATEX / IECEx / NEC / CEC
F - End of Stroke feedback
E - End of Stroke feedback + Leak Detection
R - End of Stroke NEC
Special Testing
For Special Testing options, please contact your nearest Ingersoll Rand Customer Service Representative or Distributor.
H - End of Stroke + Leak Detection ATEX / IECEx / NEC / CEC
L - Leak Detection
M -
Leak Detection
ATEX / IECEx / NEC / CEC
E - Solenoid 12 VDC NEC / CEC
F - Solenoid 24 VDC NEC / CEC
J -
Solenoid 120 VAC NEC / CEC
A -2 - 11-1/2 NPTF - 1
0 -
Standard Valve Block (No Solenoid)
S -
Cycle Sensing on Major Valve
T - End of Stroke NEC / Leak Detection NEC
0 - No Option
Specialty Code 2 (Blank if no Speciality Code)
A - Santoprene
C - Hytrel
E -Carbon Steel
F - Aluminum
G - Nitrile
H - Hard 440 Stainless Steel
L - Hastelloy - C
S - 316 Stainless Steel
A - Santoprene
C - Hytrel
G - Nitrile
S - Stainless steel
T - PTFE
V - Viton
S - Stainless Steel
C -Cast Iron
H - Hastelloy - C
S - Stainless Steel
S - Stainless Steel
A -Santoprene
C - Hytrel
G - Nitrile
L - Long Life PTFE
M - Medical Grade Santoprene
T - PTFE / Santoprene
V - Viton
F - 2“ ANSI / DIN Flange
K - Kynar PVDF
To Next Page
Loading...
