Arrakis Systems MARC-15 User Manual

S E R V I C E & M A I N T E N A N C E
Removing the Studio Monitor Module
The studio monitor module has two bus ribbon cables that connects it to the motherboard. Care should be taken when removing or
reinstalling these cables.
How to Remove a Studio Monitor Module from the Mainframe
1) Turn all power off to the console
2) Remove the two screws that attach the module to the mainframe
3) Unplug the RJ45 IO cables located at the rear of the module
4) Lift the module up from the mainframe and unplug the 30 wire ribbon cable at the motherboard. Leave the cable plugged in at the
module end.
5) Unplug the 10 wire ribbon cable at the motherboard. Leave the cable plugged in at the module end.
6) The module is now free.
6.2
Motherboard
Output
Module
Studio
Monitor
Ribbon
Cable
(10
wires)
Main
Bus
Ribbon
Cable
(30
wires)
Studio
Monitor
Module
Main
Bus
Ribbon
Cable
(30
wires)

Arrakis Systems MARC-15 Specifications

General

Brand	Arrakis Systems
Model	MARC-15
Category	Controller
Language	English