3600 SERIES USER MANUAL
3600 Series Programmable DC Power Supply
VERSION 2.10 2006.03
iii
III. Fuse
1. The fuse is at the position of power input part on the back panel, for the purpose of avoiding failure brought by
using wrong voltage. Please pay attention to the following items when you change the voltage input and the fuse.
2. Before changing the voltage and fuse, please be sure that the AC power is switching off, and be sure that there
is no other equipment connected to this instrument.
3. Put a screwdriver into the fuse mounting, press it and the fuse mounting will pop up.
4. Pull out the fuse, change it according to the label beside the power input plug.
Warning: To avoid damaging the instrument, please be sure to change a suitable type fuse.
To Next Page
Loading...
Need help?
General
