Array electronic AF-10MR-A

To Next Page

To Previous Page

FAB

ntelligent

ontrollerr

4.3.1.1 Edit PRG/New Prg

The Edit PRG Menu Frame is shown in Fig. 4.6 and the function blocks are to

be selected under this menu.

Fig 4.6

Select a Function Block

The user may use the

and keys to move the arrow > at the left to se-

lect the function blocks. Press OK to conrm the selection of a function block,

and then the Function Block Setting Frame shown in Fig. 4.6 will appear (please

refer to Chapter III Specication of function Blocks). This menu includes the

following function blocks: AND, NAND, OR, NOR, XOR, NOT, RS, UCN,

DCN, PLR, MPLR, CPG, RPR, DPR, DDR, CW, TEL, PLAY, MR, AN(D/GD

type).

Set the Function Block

When the Input Function Block is selected, FAB will automatically help you

dene in sequence the numbers of the blocks beginning with letter B and be dis-

played the said numbers in the bottom right corner (e.g. B01), as shown in Fig.

4.7.

The user can make the selection of the Input/Output and Parameter values of to-

be set function blocks by moving the keys (Please refer to the Function Block

Specication in Chapter Ⅲ for the Input/Output and Parameter value)

>AND

NAND

NOR

NOT

XOR

Array electronic AF-10MR-A - Page 54