Arris DSR-7400 Series User Manual

STARZ ENTERTAINMENT DSR-7400 SERIES QUICK START GUIDE
RF INPUTS: Connect RF inputs as labeled below.
ASI OUTPUTS: Connect ASI (or optional* IP) outputs as labeled below.
SIGNAL LOCK: Enter frequency and modulation parameters in the Quick Install menu to gain signal lock.
AUTHORIZATION: Contact Starz Affiliate Support for signal authorizations. (888) 783-2275, Opt. #2
Write down UA 1 and UA 2, as you will need these when calling 888-783-2275, Opt. #2 for authorization.
AUTHORIZATION
Hit the “OK” button with “Quick Install” highlighted as shown.
SIGNAL LOCK
Set and verify the following fields shown below:
Transponder 17 or 20
Symbol Rate 32.500
Input Port RF Port 1 or RF Port
3
Modulation Mode DVBS2
G13-V
G15-V
Transcoded
SERVICES
ASI OUTPUTS
*GigE
OUTPUT
RF INPUTS
v. T2
PAGE 1 OF 2 (SEE REVERSE)
RF Port 1
1110.00 17
16APSK 32.500

Arris DSR-7400 Series Specifications

General

Brand	Arris
Model	DSR-7400 Series
Category	Receiver
Language	English

Summary

Initial Device Setup and Configuration

Connecting RF and ASI/IP Outputs

Connect RF inputs and ASI or IP outputs to the DSR-7400 device as indicated.

Configuring Signal Lock

Configure frequency and modulation parameters via the Quick Install menu for signal lock.

Obtaining Device Authorization

Contact Starz Affiliate Support for necessary signal authorizations using provided contact details.

Quick Install Menu Parameters

Set key parameters like UA codes, RF port, modulation, and symbol rate within the Quick Install menu.

Device Connectivity and Interfaces

Video and Audio Output Ports

Description of video output and audio input/output connections on the device.

Relay, Alarm, and Control Interfaces

Details on relay contacts, alarm signals, DTMF, cue tones, and test interfaces.

Purchasing Additional Equipment

ARRIS Authorized Distributors

Contact information for ARRIS authorized distributors for purchasing additional IRDs.