To Next PageTo Next Page
Need help?Do you have a question about the Arris FPV250 and is the answer not in the manual?
General| Brand | ARRIS |
|---|---|
| Model | FPV250 |
| Frame Size | 250mm |
| Wheelbase | 250mm |
| Material | Carbon Fiber |
| Battery | 11.1V 3S LiPo |
| Propeller Size | 5 inch |
| Motor | Brushless |
Displays all the carbon fiber plates that constitute the ARRIS FPV250 frame.
Attaches damper balls to the vibration damper plate and then to the battery plate.
Secures the four arms to the main frame using M3 x 12 screws.
Adds red aluminum columns onto the screws already attached to the frame arms.
Attaches the lower plate to the main frame structure.
Attaches the landing skids to the frame using M3 x 6 screws and nuts or rubber components.
Installs aluminum columns onto the center frame using M3 x 6 screws and thread lock.
Attaches the camera fixed plate to the front part of the frame.
Secures the upper plate to the frame using M3 x 6 screws with thread lock.
Mounts the FPV camera using M2.5 x 12 nylon screws or cable ties, avoiding metal screws.
Attaches ARRIS MT1806 2300KV motors to the frame arms using M2 x 4 screws.
Connects motor wires to ESCs, involving wire trimming, soldering, and heat shrink tubing.
Secures the motors (with attached ESCs) to the frame arms using M2 x 6 screws and thread lock.
Routes ESC wires through arms, connects JST plug for video TX and main power wires, and solders XT60 connector.
Mounts the CC3D flight controller onto the lower plate using 3M double-side tape, ensuring it is level.
