Arrma 4S - Radio System Binding; Factory Defaults and Binding Procedure

WWW.ARRMA-RC.COM
Factory Defaults
Binding
Insert the Bind Plug in the
BIND port on the receiver.
ST TRIMST TRIMST TRIM
ST RATETH RATE
TH TRIM
N RN R
TH ST
TH LIM
50/75/100
ST TRIMST TRIMST TRIM
ST RATETH RATE
TH TRIM
N RN R
TH ST
TH LIM
50/75/100
ST TRIMST TRIMST TRIM
ST RATETH RATE
TH TRIM
N RN R
TH ST
TH LIM
50/75/100
ST TRIMST TRIMST TRIM
ST RATETH RATE
TH TRIM
N RN R
TH ST
TH LIM
50/75/100
ST TRIMST TRIMST TRIM
ST RATETH RATE
TH TRIM
N RN R
TH ST
TH LIM
50/75/100
Connect a fully charged battery
pack to the ESC.
Power on the ESC. The red
LED flashes, indicating the
receiver is in bind mode.
Center the ST TRIM and TH
TRIM dials on the transmitter.
Turn the steering wheel to Full
Right. Power the transmitter
on while holding the steering
wheel to the Right.
Release the steering wheel
when the receiver LED stops
flashing.
Remove the Bind Plug, then
power off the receiver to save
the settings.
Power off the transmitter.
Bind socket
ON
ST TRIMST TRIMST TRIM
ST RATETH RATE
TH TRIM
N RN R
TH ST
TH LIM
50/75/100
OFF
18