Arrma ADX-10 - User Manual

Other manuals for Arrma ADX-10

Maintenance Manual22 pages

Quick Start Guide20 pages

Questions and Answers

N
Nicholas SmithAug 22, 2025
What to do if Arrma Toy has no control or short range?
- J
  jessehallAug 23, 2025
  If you're experiencing a lack of control or short range with your Arrma Toy, check these: * The Arrma ATX transmitter batteries might be weak or incorrectly fitted. Ensure they are correctly installed. * The servo and ESC signal wires to the ARX receiver might be loose or incorrectly connected. Reinstall the signal wires to the receiver. * The Arrma transmitter and receiver might not be 'bound' correctly. They need to be bound.
J
Jill MillsAug 26, 2025
How to fix Arrma Toy that drives without input?
- P
  Patricia McgrathAug 26, 2025
  If your Arrma Toy is driving without any input, it could be due to: * The Arrma ATX transmitter throttle trim being incorrectly set. The throttle trim needs to be set to zero/neutral. * An incorrect neutral throttle position of the MEGA ESC. Set the throttle trim to zero and switch the MEGA ESC off and then on again. A chime will indicate the new neutral position has been set.
B
Bonnie GrantAug 28, 2025
Why Arrma Toy has short runtime?
- D
  Dr. Erica PenaAug 28, 2025
  A short runtime for your Arrma Toy could be caused by: * A damaged or not fully charged battery. Check its condition, and replace or recharge it. * A dirty or damaged MEGA electric motor. Clean, check its condition, and/or replace it. * An incorrect ESC battery mode, where the voltage cutoff is too high for the battery you're using. Adjust the battery mode of the MEGA waterproof ESC.
R
Ronald ThompsonAug 31, 2025
How to solve intermittent steering/throttle operation in Arrma Toy?
- S
  Sonia WangAug 31, 2025
  Intermittent steering or throttle operation in your Arrma Toy can occur if: * The ESC has shut down due to overheating. Stop driving and allow the ESC or motor to cool down. * The Arrma transmitter and receiver are not bound fully or are suffering interference. Check for sources of interference and re-bind transmitter/receiver.
J
Jeremy GriffithSep 2, 2025
How to correct reversed steering or throttle function on Arrma Toy?
- D
  Denise BrooksSep 3, 2025
  If the steering or throttle function is reversed on your Arrma Toy: * The relevant channel of the Arrma ATX transmitter might be reversed. Reverse the relevant channel on the Arrma ATX transmitter. * Check that the wires from the ESC to the motor are connected correctly. Reconnect in the correct orientation (orange to red and blue to black) ensuring fit is tight; if not pinch female connector with pliers
K
Kevin SmithSep 5, 2025
Why Arrma Toy vehicle does not reverse?
- K
  katherinesmithSep 5, 2025
  Your Arrma Toy vehicle might not be reversing because: * The ESC reverse mode is switched off. Adjust reverse on the MEGA waterproof ESC. * The MEGA Waterproof ESC is damaged. Replace it with a new unit.
U
utuckerSep 8, 2025
What causes limited steering angle in Arrma Toy?
- H
  Hannah RyanSep 8, 2025
  A limited steering angle in your Arrma Toy can be due to: * The Arrma ATX transmitter steering dual-rate being set incorrectly. Adjust the Arrma ATX transmitter dual-rate. * Damaged steering components. Check components and replace them. * A damaged MEGA waterproof ESC. Replace it with a new unit.
C
Cheryl OrtizSep 12, 2025
How to stop Arrma Toy front wheels lifting when accelerating?
- T
  Tiffany ParkerSep 12, 2025
  If the front wheels of your Arrma Toy lift when accelerating, it's likely that the slipper clutch adjustment is too tight. Check if the slipper is set to the factory setting.
K
Kirsten ParkerSep 13, 2025
Why does Arrma Toy vehicle wander left or right without steering input?
- R
  rkochSep 13, 2025
  If your Arrma Toy vehicle wanders left or right without steering input: * The Arrma ATX Steering trim setting might be out. Adjust the steering trim. * There may be damaged steering components. Check components and replace them. * The drivetrain might be dirty or damaged. Clean, check its condition and/or replace it.
X
xsimmonsNov 16, 2025
Why Arrma Toy vehicle does not move?
- S
  Stacy ParsonsNov 16, 2025
  Your Arrma Toy vehicle might not be moving due to several reasons: * The batteries in the Arrma ATX transmitter might be incorrectly installed. Check and refit them. * The drive battery in the model could be weak, damaged, or missing. Install a fresh, charged battery. * There might be frayed or broken motor or ESC wires. Check their condition, reconnect, and insulate them. * The ESC might have shut down due to overheating. Allow the ESC or motor to cool down. * The MEGA electric motor or waterproof ESC might be damaged. Replace it with a new unit. * There could be damage to the transmission/drive-line. Check the components and replace them. * The ESC low voltage cutoff might have activated to protect the batteries. Remove the drive battery, let it cool down if needed, and re...

Arrma ADX-10 Specifications

General

Scale	1/10
Wheelbase	285mm / 11.22"
Weight	1.47kg / 3.24lbs
Drive Type	4WD
Radio System	2.4GHz
Vehicle Type	Buggy
Suspension	Independent
Body Material	Polycarbonate
Battery Compatibility	LiPo