Arrma Mojave - User Manual

40 pages

Save Page as PDF

To Next Page

380037

Main Page

Other manuals for Arrma Mojave

Maintenance Manual22 pages

Quick Start Guide20 pages

Questions and Answers

L
ldelacruzNov 18, 2025
What to do if Arrma Toy has sluggish performance?
- D
  Derrick PierceNov 18, 2025
  If your Arrma Toy is performing sluggishly, consider the following: * The battery might be damaged or not fully charged. Check its condition and replace or recharge it. * The Arrma ATX transmitter throttle trim might be incorrectly set. Ensure the throttle trim is set to zero/neutral. * The neutral throttle position of the MEGA ESC might be incorrect. Set the throttle trim to zero, then switch the MEGA ESC off and on again to set a new neutral position. * The slipper clutch adjustment might be too loose. Check if the slipper is set to the factory setting or your preferred setting. * The initial acceleration mode or reverse speed on the MEGA waterproof ESC might be set too low. Modify the MEGA waterproof ESC settings. * The MEGA electric motor might be dirty or damaged. Clean, ...

Summary

Warnings

General Safety Information

General safety precautions for operating the RC model and handling batteries.

Warranty Information

Kit Overview and Requirements

Kit Overview

Visual introduction to the ARRMA models and included components.

Required Items for Operation

Lists essential items and kits needed to operate the RC model.

Battery Charging Guide

Chassis Component Overview

Radio Gear Operation and Setup

Transmitter Control Panel Functions

Explanation of the transmitter's control panel layout, buttons, and indicators.

Binding Transmitter to Receiver

Step-by-step procedure for binding the transmitter to the RC model's receiver.

Electronic Speed Controller (ESC)

ESC Specifications and Defaults

Details on input voltage, BEC output, FCC ID, and factory default settings.

ESC Operation and Tuning

ESC Status, Protection, and Throttle Setup

Understanding ESC LED indicators, protection features, and throttle neutral setup.

ESC Tuning Options

Details on adjusting battery mode and reverse lock-out settings via jumpers.

Initial Operation and Driving

Battery Fitting and First Run

Steps for fitting the battery and preparing for the initial driving session.

Driving Fundamentals

Basic driving techniques for handling, cornering, and controlling the vehicle.

Post-Drive Checks

Essential checks to perform on the vehicle after each driving session.

Maintenance and Troubleshooting

Recommended Maintenance Tools

List of tools required for performing maintenance and repairs on the RC vehicle.

Troubleshooting Common Vehicle Issues

Matrix to identify and resolve problems related to vehicle movement and input.

Maintenance Schedule

Chassis, Drivetrain, and Suspension Maintenance

Schedule for maintaining chassis, drivetrain, driveshafts, and suspension components.

Wheel, Axle, and Bearing Maintenance

Schedule for maintaining wheels, tyres, axles, and bearings.

Shock and Differential Maintenance

Schedule for maintaining shock absorbers and differentials.

Chassis Maintenance Procedures

Wheel and Tyre Maintenance

Slipper Clutch Adjustment

Spur and Pinion Gear Mesh Adjustment

Slipper Pad Replacement

Driveshaft Maintenance

Rear Axle Maintenance

Wheel Bearing Replacement

Raider Factory Settings

ADX-10 Factory Settings

Mojave Factory Settings

Vorteks Factory Settings

Granite Factory Settings

Chassis Tuning Guide

Ride Height Adjustment

Instructions on setting ride height using spring spacers for ground clearance.

Camber Link and Position Adjustments

How to adjust camber link length and position for optimal handling characteristics.

Steering Arm and Shock Position Tuning

Adjusting steering arms for toe and shock positions for damping and cornering.

Shock Absorber Tuning

Shock Removal and Spring Changes

Steps to remove shocks and change springs for performance tuning.

Shock Oil Replacement Guide

Detailed steps on how to change shock oil viscosity for damping adjustment.

Drivetrain Tuning and Gearing

Gear Chart and Ratio Selection

Chart to help choose appropriate gear ratios for desired speed and acceleration.

Spur and Pinion Gear Replacement

Procedures for removing and replacing spur and pinion gears for drivetrain maintenance.

Motor and Differential Tuning

Motor Removal and Installation

Steps for removing and installing the vehicle's motor for cleaning or upgrades.

Differential Tuning with Oil Weight

How differential oil affects handling and the process of tuning with different oil weights.

Differential Removal and Replacement

Differential Components and Exploded View

Radio Gear Maintenance

Receiver Access and Handling

Steps to access and work with the radio receiver unit for setup or replacement.

Steering System Access

How to access the steering mechanism for adjustments or servo replacement.

Servo Removal and Upgrade Guide

Front Exploded View - Raider;ADX-10

Front Exploded View - Granite;Vorteks

Front Exploded View - Fury;Mojave

Centre Section Parts - Raider;ADX-10

Centre Section Parts - Granite;Vorteks

Centre Section Parts - Fury;Mojave

Rear Section Parts - Raider;ADX-10

Rear Section Parts - Granite;Vorteks

Rear Section Parts - Fury;Mojave

Gearbox Assembly Details

Option Parts and Upgrades

Tuning Settings Sheets - Raider;ADX-10

Tuning Settings Sheets - Mojave;Vorteks;Granite

Arrma Mojave Specifications

General

Scale	1:7
Drive type	4-wheel drive (4WD)
Motor type	Brushless
Suspension	Yes
Engine type	Electric engine
Product type	Off-road car
Housing color	Black, Red
Maximum speed	96 km/h
Chassis material	Aluminum
Housing material	-
Suggested gender	Boy/Girl
Channels quantity	2 channels
Construction type	Ready-to-Run (RTR)
Bearing technology	Ball bearing
Protection features	Water resistant
Transmitter frequency	2.4 GHz
Quantity	1
Batteries included	No