EasyManua.ls Logo

Arrma SPECTRUM SLT2 - TROUBLESHOOTING

Arrma SPECTRUM SLT2
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WWW.ARRMA-RC.COM
WWW.ARRMA-RC.COM
Problem Possible Cause Solution
Vehicle does not
move
Batteries are incorrectly installed in transmitter
Check transmitter batteries and ret -
see model/transmitter manual
Weak, damaged or no drive battery in model Install fresh, charged batteries
Frayed or broken motor or ESC wires
Check condition, reconnect and
insulate
ESC has shut down due to overheating
Stop driving and allow ESC or motor
to cool down
Electric motor is damaged
Replace with new unit - visit
ARRMA-RC.com for advice and
upgrades!
Waterproof ESC is damaged
Replace with new unit - visit
ARRMA-RC.com for advice and
upgrades!
Possible damage to transmission/drive-line
Check components and replace -
visit ARRMA-RC.com for advice
ESC low voltage cuto󰀨 has activated to protect
batteries
Remove drive battery, leave to cool
down if necessary, and re-charge
Vehicle does not
reverse
Waterproof ESC is damaged
Replace with new unit - visit
ARRMA-RC.com for advice and
upgrades
Short runtime
Battery damaged or not fully charged Check condition, replace or recharge
Electric motor dirty or damaged
Clean, check condition and/or replace
- visit ARRMA-RC.com for more
information
Sluggish
performance
Battery damaged or not fully charged Check condition, replace or recharge
Electric motor dirty or damaged
Clean, check condition and/or replace
- visit ARRMA-RC.com for more
information
Drivetrain dirty or damaged
Clean, check condition and/or replace
- visit ARRMA-RC.com for more
information
No control of
vehicle or short
range
Transmitter batteries are weak or tted incorrectly
Check transmitter batteries and ret -
see page 14
Servo wires to receiver loose or connected incor-
rectly
Reinstall signal wires to the 2-In-1
Unit
Transmitter and receiver unit are not 'bound' cor-
rectly
Transmitter and receiver need to be
bound - see page 21
Troubleshooting
23

Related product manuals