Page 12 · 6300 Series ComboSource User’s Manual
button, primary used when making changes in the menu, but can also be used
to change the view mode in the main display (see Main Display Screen below).
There are eight LEDs: two blue LEDs to indicate the on/off state of the laser or
TEC; a red Error LED that indicates an error has occurred; a yellow Remote
LED that indicates the unit is being controlled via a computer; two green LEDs to
indicate which set point will be adjusted by the knob; and two more green LEDs
to indicate which current control range is active.
Whenever an error is generated, the red Error LED will light, and the error will be
displayed on the VFD display. There may be one or more errors, but only the
first error will be displayed. To display the next error, press Menu button. To
clear all errors, press the knob. A list of error codes can be found in the Error
Messages section below.
When the unit is in remote mode, the yellow Remote LED will be lit. More
information about how the instrument behaves in remote mode can be found in
the Remote Mode Operation section below.
Main Display Screen
On the main display you will find both set points and measurements. Which set
point and measurements are displayed is dependent on the control mode you
have selected.
You can select which set point is adjusted by pressing the Select button. The
active set point is displayed on the screen via inverted text, and either the Laser
or TEC selection LED will be lit.
You can also control the size of the characters by enlarging either the Laser, the
TEC, or both. When on the main display, this can be done by pressing the Enter
button (the knob), or by changing the Display setting in the System menu.
When in large display mode, only the actual operating value is displayed. When
the set point is changed via the knob, the display will briefly show the set point,
and then return to displaying the actual measurement.
To Next Page
Loading...