9
SPECIFICATIONS
Input Connections XLR female balanced (Mic, channels 1-8)
1/4-inch TS unbalanced (Line, channels 1-8)
RCA unbalanced (Aux Bus In, Left and Right)
Output Connections 1/4-inch TRS balanced (Main Outputs, Left and Right)
RCA unbalanced (Prefade Out, Left and Right)
Input Impedance 2k Ohms (Mic), 20k Ohms (Line), 51k Ohms (Aux Bus In)
Output Impedance 200 Ohms (Main Outputs, balanced),
100 Ohms (Prefade Out)
Frequency Response 20 Hz – 20 kHz (+0, -1 dB) (CH 1-8 in, Main out)
THD <0.01% @ 1 kHz, typical
Phase Response All connections are phase coherent
Signal to Noise Ratio >99dB typical (Ref 0dBu)
CMRR >43 dB typical
All PAN controls centered for the following level and gain measurements:
Maximum Input Level -4 dBu (Mic), +22 dBu (Line)
Maximum Output Level +24 dBu (balanced), +18 dBu (unbalanced)
Maximum Gain 54 dB (Mic), 29 dB (Line)
Phantom Power Switch selectable, +48V DC (regulated and filtered),
7 mA current limiting per leg
Power Requirements USA: 95-125 VAC, 50-60 Hz, <15W
Export units configured for country of destination
Dimensions (HWD) 1.75-inch x 19-inch x 6-inch
44.5mm x 483mm x 152mm
Weight 6.3 lbs. (2.9 kg)
Note: 0 dBu = 0.775Vrms
ART maintains a policy of constant product improvement. ART reserves the right to make changes
in design, or make additions to, or improvements upon, this product without any obligation to install
same on products previously manufactured. Therefore, specifications are subject to change without
notice.
To Next Page
Loading...
