Need help?Do you have a question about the ARTECO Everywhere 3.0 and is the answer not in the manual?
General| Brand | ARTECO |
|---|---|
| Model | Everywhere 3.0 |
| Category | Controller |
| Language | English |
Guidelines for inspecting packaging, handling ESD, and environmental conditions.
Details power options (PoE, 12/24 VDC) and DIN rail installation requirements.
Describes P1 and P2 connectors, their pins, and functions for inputs/outputs.
Explains how to connect devices with relay or dry-contact outputs to the module.
Details default IP, username, password, and homepage layout for web access.
How to view and control outputs and inputs via the web interface.
Configuring the system for notifications and sequential actions.
Settings for sending email notifications, including server and trigger conditions.
Configuring output modes (switch/button) and timing parameters.
How to send user-definable HTTP commands to remote devices.
Managing slave module inputs/outputs from a master module.
Writing and executing sequences of actions using hardware resources.
Configuring host name, DHCP, IP, gateway, subnet mask, and DNS.
Setting up DDNS for internet access and scheduling network pings.
Configuring date, time, NTP, and user credentials for the device.
Performing firmware updates, system restore, and other operations.
Steps for updating the device's firmware from a Windows PC.
Associating custom names with input/output channels for clarity.
Scheduling output actions based on days and times using time slots.
Locating the reset button and performing the factory reset.
Explains CGI commands, authentication, and the "info" command.
Details "monitor", "io", "set", "byte", and "mirror" commands for status and control.
Covers "var", "input", and "seq" commands for labels, inputs, and micro-PLC control.
To Next Page