Reprint Results?
(Yes/No)
Delete Data Points?
(Yes/No)
Enter Pt # to Delete
• If, at the end of the run, a second copy of the results is
desired, press YES at the next prompt (Figure 14).
• If it is determined that a given data point may be eliminated
from the statistical calculation, press YES at the next prompt
(Figure 15).
• Enter the sample # of the data point to be deleted at the next
prompt (Figure 16).
• At the next prompt to delete more data points, follow the
same steps until all appropriate data points are deleted.
• The correct statistics will be printed.
• For suggested tolerance limits, refer to section 4.13 of the
Procedure Guide.
Figure 14
Figure 15
Figure 16
Completing
Calibration
PCS Quickstart-15A3179_PCS Quickstart 15A3179 Rev 4/3/13 2:02 PM Page 14
To Next Page
Loading...
