50
Topside Controller Instructions
Initial Start up / Setting the Time of Day
After the spa has been powered up and the topside controller is
finished displaying “Pr”, the user may control the various pumps,
lights, temperature of the water, filter cycles, and choose between
different modes of operation from this topside controller.
Setting the Time of Day
When the spa is first powered up, the words “SET TIME” will flash on
the display to set the time, press “Time”, then “Mode”, then “Warm”
or “Cool”. After “Warm” or “Cool” is pressed once, the time will
begin changing in one-minute increments. Press “Warm” or “Cool”
to stop the time from changing. Press “Time” to enter your correct
time into the system.
Topside control for Island models
To Next Page
Loading...
