51
Light/ Mode/ Jets
Light
Press the “Light” button to turn the light on and off. If left on, the
light automatically turns off after 4 hours.
Mode
The mode is changed by pressing the up or down arrow then the
mode key.
Standard Mode is programmed to maintain the desired tempera-
ture. Note that the last measured spa temperature is current only
when the pump has been running for at least 1 minute. “St” will be
displayed momentarily when you switch into Standard Mode.
Economy Mode heats the spa to the set temperature only during
filter cycles. “Ec” will display solid when temperature is not current,
and will alternate when temperature is current.
Sleep mode heats the spa to within 20°F/10°C of the set tempera-
ture only during filter cycles. “SL” will display solid when tempera-
ture is not current, and will alternate when temperature is current.
Jets
Touch the “Jets 1” “Jets 2” or “Jets 3” button once to activate the
respective pump and its jets. (See the line drawings on pgs. 6-37
for pump zones). Touch the respective “Jets” button again to turn
off the pump. If left running, the pumps will automatically turn off
after 15 minutes.
To Next Page
Loading...
