Topside Controller Instructions
Initial Start up / Setting the Time of Day
53
After the spa has been powered up and the topside controller is
nished displaying “Pr”, the user may control the various pumps,
lights, temperature of the water, lter cycles, and choose between
different modes of operation from this topside controller.
Setting the Time of Day
When the spa is rst powered up, the words “SET TIME” will ash on
the display to set the time, press “Time”, then “Mode”, then “Warm”
or “Cool”. After “Warm” or “Cool” is pressed once, the time will
begin changing in one-minute increments. Press “Warm” or “Cool”
to stop the time from changing. Press “Time” to enter your correct
time into the system.
Topside control for Island models
To Next Page
Loading...
