MAINTAINING YOUR SPA cont...
REMOVING, INSTALLING AND CLEANING FILTERS
These are the steps needed to successfully replace your lters.You
should replace your disposable spa lters and clean your nondispos-
able lters every four months.
1) Turn off all power to your spa and remove
the lter lid by lifting it out towards you.
2) Turn the lter counterclockwise and
remove it from the lter well.
3) Dispose of the used lter.
5) To replace, set screen back into its place
and turn clockwise to fasten. DO NOT
over-tighten.
6) Place the new lter into position and turn
clockwise to fasten. DO NOT over-tighten.
7) We recomend the use of a quality lter soak product.
Please contact your dealer to purchase all all your spa care
products.
WARNING: Power to your spa must be turned off prior to remov-
ing your lters. The suction at the lter is extremely strong and
can cause injury if there is no lter. NEVER run your spa without
the lters properly installed. Injury to person and damage to the
equipment can occur. Any damage to equipment due to this cir-
cumstance will not be covered under warranty.
61
To Next Page
Loading...
