EVNOVO 3D Printer
SW-X1
List 1
List 2
M4x45 (5pcs)
Step 1
M4x45 (4pcs)
Fix the XZ gantry to the base with 4pcs of M4x45
screws as shown in picture。
Step 2
Fix the spool holder to the top of the printer, adjust
the width to fit the size of your filament spool. Make
sure the filament sensor is facing forward.
Step 3
Connect the filament runout sensor as shown in
pictures below:
Step 4
Fix the Z Endstop to the frame as shown in pictures
below. The distance between the sensor top and base
top should be approx 75mm.
Step 5
Connect the Z Stepper Motors as shown in picture
belows:
Front
75mm
To Next Page
Need help?
General
