Need help?Do you have a question about the Artillery GENIUS and is the answer not in the manual?
General| Build Volume | 220 x 220 x 250 mm |
|---|---|
| Filament Diameter | 1.75 mm |
| Nozzle Diameter | 0.4 mm |
| Connectivity | USB, SD Card |
| Bed Leveling | Manual |
| Max. Nozzle Temperature | 240°C |
| Max. Bed Temperature | 130°C |
| Print Technology | FDM (Fused Deposition Modeling) |
| Printing Speed | 60 mm/s |
| Supported Materials | PLA, ABS, TPU |
| Frame Material | Aluminum |
| Display | Touch Screen |
| Power Supply | 110V/220V |
| Layer Resolution | 100 - 300 microns |
Warns against opening the printer while powered on and advises unplugging the AC cord.
Advises against touching hot components like the nozzle, heater block, or bed until cool.
Recommends keeping flammable materials away from the printer during operation.
Caution to avoid fingers near moving parts like belts, pulleys, and gears.
Advises grounding oneself before touching electronics to prevent damage.
Recommends adult supervision for users under 18 and warns of choking hazards.
Steps to pre-heat the nozzle/bed and level the print bed.
To Next Page
