13
Slicer Preparation - Step 5
If it’s your first time installing Repetier-Host, you may see the
“Welcome to the Slic3r Configuration Wizard” window, please follow
the steps below to set it up.
Firmware Type - RepRap (Marlin/Sprinter)
Bed Size - Shape: Rectangular; x: 220; y: 220
Nozzle diameter - 0.4
Filament Diameter - 1.75
Temperature - according to your filament, usually 220 for PLA is fine
Bed Temperature - 80 for PLA, 130 for ABS
To Next Page
Loading...
