09
Slicer Preparation - Step 1
This printer works with most slicing / printing software like Repetier-
Host, Cura, Simplify3D etc. But we will go in details for Repetier-Host
and tell you how to set it up so that you can make your first print. First,
install the Repetier-Host software comes on the USB stick or you can
download a copy from http://www.repetier.com.
During installation process, uncheck Repetier-Server in Select
Components step (unless you know what it is and needed it).
After installation and start the software, you should see the following
screen:
To Next Page
Loading...
