GENERAL OPERATING/WARRANTY MANUAL FOR CHILLER, FREEZER AND HEATED DISPLAY CABINETS
51
IMPORTANT RESPONSIBILITIES OF CABINET OPERATORS
➤
Correct and consistent power supply
➤
No direct sunlight on units
➤
Product to go into cabinet at desired holding temperature
➤
Max. ambience: 40°C & 60% R.H. – unless otherwise advised or stated on cabinet.
➤
Do not turn off at power switch regularly
➤
Observe all details and instructions in MANUAL
➤
Have a qualified mechanic check/clean unit every 3 months (your account)
➤
Follow cleaning and operating procedures, set out in manual, on a daily, weekly and regular basis as specified
➤
Level Floor
➤
Cabinet to be at correct temperature before being loaded
➤
Water quality is the responsibility of the owner/operator and any part affected will not be covered by warranty
FAILURE TO PERFORM THE ABOVE (ON YOUR OWN ACCOUNT) WILL VOID WARRANTY
AND PERFORMANCE PARAMETERS OF YOUR UNIT
CLEANING PROCEDURES
Always disconnect from power source firstly, and be careful with sharp edges.
Cleaning procedures are very important; carefully follow the manual.
DO NOT hose or splash water in, or about, your cabinet.
DO NOT use bleaches, chlorine, etc. use only mild detergents.
The drains are only for condensate (not waste).
*Clean carefully. Wiping out areas and ensuring drain lines are clear and clean.
BLOCKED DRAINS AND DAMAGE TO ANY COMPONENT CAUSED BY BLOCKED DRAINS
WILL NOT BE COVERED BY WARRANTY
To Next Page
