Artsound R99 - Entering Security Code for Your Wireless Network; Before You Start; Getting Started; Network Setup

R99
4
5. ENTERING SECURITY CODE FOR YOUR WIRELESS NETWORK
6. BEFORE YOU START
7. GETTING STARTED
8. NETWORK SETUP
USING REMOTE CONTROL
On the alpha-numerical keypad, press buttons repeatedly to cycle through the letters, numbers and symbols as
listed below.
To input a character, scroll to the correct one and when it is highlighted, press the [⊲] button to input the next
character. When it comes to the last character of the password and it is highlighted, press [OK] to confirm.
USING CONTROL BUTTON ON THE RADIO UNIT
Use the [Tune/Select] knob to scroll through the characters, when the correct one is highlighted, press [⊲] button
to input the next character. When it comes to the last character of the password and it is highlighted, press and
hold the [Tune/Select] to confirm.
Note: The security code is case sensitive.
Button 1: 1 and dierent kind of
symbols !@#$%^&*()_+[]{};:'”\|,./<>?
Button 2: 2ABCabc
Button 3: 3DEFdef
Button 4: 4GHIghi
Button 5: 5JKLjkl
Button 6: 6MNOmno
Button 7: 7PQRSpqrs
Button 8: 8TUVtuv
Button 9: 9WXYZwxyz
Button 0: 0
Please ensure the following is ready:
You have a broadband internet connection.
A wireless broadband router is connected to the internet successfully. The radio supports Wireless B, G and N
connection (Wireless N router can also be used with the setting on B or G). You know the Wired Equivalent
Privacy (WEP) or Wi-Fi Protected Access (WPA) data encryption code/password. You need to key in the correct
code when the radio is connected to the wireless router for network connection. If you do not know the code/
password, please contact the person/technician who set up the router/network for you.
The radio can work via Wireless network connection (Wi-Fi connection) and Wired connection (Ethernet Rj45).
• Remove internet radio tuner (called Tuner hereafter) from the package box. There are two external antennas
included in the accessories. Both are identical. Connect them to the connectors at the back of the Tuner,
labelled with BT Antenna and WiFi antenna respectively. Without the antennas installed, the WiFi and Bluetooth
function do not work properly.
• Plug in the DC adapter and switch the Power on/o switch (on the rear
• cabinet) to ON. The Tuner will turn on automatically.
• Caution: Use only the adaptor supplied with the radio. Connecting a power supply with a dierent rating will
cause permanent damage to the radio and may be hazardous.
• The Tuner is intended to connect with external powered speaker. It does not have amplifier and speaker driver
built-in. Please connect your stereo through the Analogue output or Digital output located on the rear panel of
the Tuner for listening.
Internet connection can be setup via Wired LAN or Wireless LAN (WiFi).
Your Radio requires a broadband Internet connection through wired Ethernet or WiFi. The easiest way is use a
CAT 5 or CAT 6 cable to connect through wired Ethernet to a Wifi router, which connects to an Adsl modem or a
cable modem provided by your ISP.